What Is the Commissioning Work After the Installation of Intelligent Parking Lot Management System_

After the installation of any kind of equipment, for the subsequent normal operation of the equipment, the first thing is to carry out the equipment commissioning, but the preparation before commissioning will be different for different equipment. What are the commissioning tasks for the intelligent parking lot management system? For the parking lot management system, it works 24 hours a day when installed in the parking lot, so it must be well debugged when the equipment is put into use. For electrical equipment, we first need to test the intelligent parking lot system before power on, check the wiring of the parking lot system according to the wiring diagram of the whole system and the wiring diagram between each equipment, ensure that the wiring of the whole system is correct, without short circuit and open circuit, and check whether the switch buttons of each equipment are flexible after power on, Check the main power supply in the sentry box or control room. Secondly, after the intelligent parking lot management system is powered on normally, test different incoming and outgoing vehicles. 1. Test of card reading and gate opening functions of vehicles: Test temporary cards, monthly cards, stored value cards, etc. at the entrance and exit, and display and read different contents for different cards on the display screen of ticket box of parking lot system. 2. Test on the function of restricting temporary card retrieval and card reading: carry out ground sense restriction on the entrance and exit control machine, place iron objects on the ground sense, and take a temporary card from the card retrieval port of the ticket box. At this time, the gate will be opened. If the vehicle does not leave the ground sense, one card cannot be removed or other cards cannot be read. The card can be retrieved only when the vehicle leaves. In addition, If the card at the ticket box door is not removed within the time specified by the system, this operation will be cancelled. 3. Function test of card reading and opening without ground sense: in this case, manual card issuing is required. The ticket box of the parking lot system does not provide card spitting function, and the rest are the same as the test steps with ground sense. Finally, the parking lot charging function test is to load the charging standard of the parking lot into the control machine at each entrance and exit, read various cards according to the above method, and judge whether the charging situation is correct. For the parking lot system, in order to ensure the stable operation of the equipment, we need to continuously and repeatedly test some of its unique functions during the test to ensure that the parking time and charging amount of vehicles are correct. For some non-standard functions, we also need to carry out non-standard testing.