If the Parking Lot Gate System Is Abnormal, How to Simply Find Out the Problem- TigerWong Technology

The use frequency of the parking lot gate is very high, and it has to rise and fall unrestricted every day, so the possibility of problems is also high compared with other equipment. Then how can we simply identify the problems? We need to suit the remedy to the case: the motor runs, but the brake rod has no response. Check whether the clutch of the lower swing arm is closed. after the brake lever rises to the limit position, no matter it is automatic or manual button, the brake lever cannot be lowered. When the vehicle detector crashes, press and hold on and off at the same time to forcibly reset the vehicle detector, or power off and then power on. continue upward or downward after the brake rod is in place. Check whether the limit switch of the gate is damaged and replace the limit plate when the power is turned on, the gate rod moves up and down. The bidirectional thyristor in the control box is broken. Replace the thyristor or replace the control box. when the vehicle leaves the vehicle detector, the brake rod cannot fall automatically. The controller of the vehicle detector has no signal output, or the ground inductance crashes, or the ground inductance coil is damaged. It is necessary to replace the vehicle detector or ground inductance coil. the gate cannot fall down after rising. The switch button of the manual button is broken, and the button should be replaced or repaired; The control box is broken. Replace the control box. the gate cannot rise after falling. Properly adjust the lower limit of electronic limit to make the brake rod fall a little above the horizontal; Or the control box is broken, replace the control box. if the brake rod does not move, there may be the following reasons: check whether there is a power supply or whether the power supply voltage is within the rated voltage. check whether the safety tube on the control box has been burnt out. check the line to see if the wire ends on the terminal of the control box are in good contact. the thyristor of the control box is broken, and the control box needs to be replaced in case of problems. the pin fixed between the main shaft of the gate and the swing arm is broken or misaligned. there are two common situations if the road gate rod shakes: the road gate rod shakes when it falls: it indicates that the tension of the spring is small and the gravity of the road gate rod is too large. At this time, the set spring tension is not enough to stably pull the road gate rod to fall slowly. At this time, the tension of the spring must be increased; the gate rod shakes when it is lifted: it means that the spring tension is large and the gravity of the gate rod is too small. At this time, the set spring tension has exceeded the gravity of the gate rod. In the process of lifting, the gate rod will be forcibly pulled up and shake occurs. At this time, the spring tension must be reduced. Last note: if the gate cannot act, power off in time, otherwise the control box will burn. If you need help, you can call directly or visit tigerwong's official website to share more industry consultation, parking plans and wonderful cases with you!!!