Eight Key Points of Construction Wiring of Intelligent Parking Lot Management System Tigerwong Techn

With the difficulty of parking getting more and more attention, many domestic parking lots are installing intelligent parking system, and the traditional parking system has been gradually eliminated. With the development of society, car parking management system is also widely used in various industries. If the car parking management system is used, it is inevitable to construct wiring for the car parking management system. If it is not installed in place during construction wiring, it will affect the use of the car parking management system. Let's take a look at how to correctly and reasonably construct wiring for intelligent car parking system.

I. the signal line of the control main board used in the parking lot system cannot be laid in parallel with the AC power line, so it should be avoided to wear in the same PVC pipe as far as possible. II. When wiring the parking lot system, it is necessary to avoid wires from generating joints. If a joint is necessary, the joint shall also be crimped or welded and waterproof. III. the wire ends connected to all external equipment in the parking lot wiring shall not be too long to avoid short circuit caused by exposure. When wiring the parking lot system, the cables must be marked to facilitate future installation, commissioning and maintenance.

IV. if the entrance and exit of the parking lot is on a slope, the control box needs to be installed on a flat road or a cement pouring platform. It is recommended to try to avoid starting on a half slope when swiping the card. V. before wiring in the parking lot, the pipe hole shall be cleaned first, and butter or talc powder shall be applied when threading and laying the cable. The cable entering the pipe orifice shall be kept straight, and moisture-proof, anti-corrosion and other treatment measures shall be taken. Vi. generally, polyethylene awg16-22 multi-core high-temperature sheathed wire can be selected for the installation of ground induction coil, instead of PVC insulated wire.

The wiring of ground induction coil is to cut a square nest with a depth of 10cm and 2x0.8m, and the four corners are cut into 45 & deg; It is recommended to put the ground induction coil in circles. Generally, it is placed in 5-6 layers. It is best to compress between each layer of the coil, and there is no joint inside the coil. The output end of the ground induction coil is twisted to the gate, and the shorter the distance, the better. After connecting, seal the nest with dry cement.

VII. When wiring the parking lot system, the distance between each equipment shall be adjusted appropriately according to the site conditions. If there is no equipment in the system, the wire required for the equipment does not need to be laid. The size and placement position of the entrance and exit control machine, the entrance and exit parking lot gate and the entrance and exit camera are the same, and the size of the ground induction coil is the same. VIII. If the booth of the parking lot management charging system is equipped with air conditioner, the AC power supply used needs to be wired separately when wiring the parking lot system, and can not be threaded in the same pipe slot with the signal line and low-voltage DC power line. At the same time, it is suggested that the size of the AC power line for power supply should be fully reserved.

Intelligent parking lot is the best way to solve the difficulty of parking. The transformation of urban traffic should make full use of the means of the Internet to meet the purpose of a more scientific, standardized, effective, fast, safe and convenient intelligent parking lot automatic management system for people's work, life and entertainment environment. The intelligent car parking management system will provide a more safe, comfortable, convenient The fast and open intelligent and information-based living space has better promoted the healthy development of the humanistic environment. Tigerwong parking equipment supplier has focused on parking equipment for many years! If you have any questions about the parking system, welcome to consult and communicate.