How to Install the Parking Lot Sensing Coil_ Taigewang Technology

As an important part of the parking lot system, the normal operation of the ground induction coil affects the correct operation of the parking lot gate, so how to install the ground induction coil is the norm? The following figure is the installation drawing of our taigewang earth induction coil. We can see from the figure that the center of the ground induction width is below the gate rod, which must be noted. The coil is 500mm away from the gate edge. Cut the ground of the lane into a 1000x2000 square groove (width * length), the groove width is 8-10mm, the groove depth is 30-50mm, the inclination angle is 60 degrees, and the corner needs to be polished and smooth. Then put the ground induction coil in turn. Pay attention to the compression between them. There is no joint in the coil. Put the coil in 6 to 8 layers, neither more nor less. Because the number of turns of the coil affects the induction strength, if the more turns are put into the coil, the greater the input inductive reactance, which may cause an open circuit. On the contrary, if the number of turns is too small, the inductive reactance is small, which will cause a short circuit. After placing the coil, we'll seal it with dry cement. After the ground induction coil is installed, we need to test. When the ground induction red light flashes, we put an iron plate on the coil. When the red light is on for a long time, remove the iron plate. If the gate can fall automatically, the installation is successful.