Common Faults of Parking Lot Gate Or Corresponding Solutions_ Taigewang Technology

1、 The embedded wire of the coil is loose. When the coil is not firmly fixed at the ground bottom, the ground vibration caused by the car on the road will cause the coil to deform and change the initial inductance of the ground. In this way, the sensor must be reset before it can work normally. The solution is to pour the melted asphalt into it and fix it. 2、 The position control magnet is moved up and down in place, and the CI min Hall element is used. If the position of the rectangular magnet and the disc with cam of the reducer changes, the position will be inaccurate. It can be adjusted accurately without turning over, that is, parking space guidance can solve the problem. 3、 The crank arm screw is loose. If this screw is loose, it will cause inaccurate upper and lower positions of the brake rod and large shaking when stopping the rod. Hang the bolt tightly and lock the nut. 4、 The power-off protection switch is powered off. When the control part of the machine fails, the automatic protection device of the machine will work automatically. At this time, the gate lever stops at the inclined position, the main power supply is disconnected, and the machine does not work. At this time, open the machine door and rotate the belt clockwise to the upper position to restore the position. If you can't restore the original state after many attempts, you need to check whether the hall element and circuit board are faulty.