What Are the Trial Operation Steps of Parking Lot Management System- TigerWong

License plate recognition parking lot system is an important part of weak current intelligent project. It is more systematic and professional. It forms an intelligent project together with video monitoring, building intercom, anti-theft alarm, audio and video public broadcasting, etc. the parking lot system manages the vehicle access and charge management in the whole building complex area, It is important to ensure the normal and stable operation of the parking lot system, so comprehensive inspection and commissioning must be carried out after the construction of the parking lot. What are the steps for the trial operation of the license plate recognition parking lot system? 1 Inspection of equipment circuit of parking lot system the parking lot system belongs to electromechanical equipment, which connects electrical appliances and electronic components through various cables. The strong current and weak current parts are used. It is recommended to check whether the power supply voltage is 220V from the strong current inspection, that is, a live wire and a zero wire. It is best to use a multimeter to detect, because there are many three-phase wires during construction, There may be two live wires with a voltage of 80V, which is very important. Almost all of these reasons burn out the electrical equipment. Then check whether the wires are wrongly connected according to the circuit diagram, whether the communication lines of weak current part can bus positive and negative levels, and whether the connection of weak current equipment lines is correct. After checking, you can power on and test run. 2 The parking lot equipment can be powered on after checking that the line is correct. After power on, check whether all mechanical and electrical equipment are started normally, the power on is normal, the communication function of weak current system is normal, and connected to the network. 3 After the parking lot system can be powered on normally, the relevant equipment parameters can be set according to the actual needs, including the setting of charging management system, number of vehicles, communication protocol port, administrator authority and charging standard; Entrance and exit gate controller (ticket box) setting: address code setting, vehicle detector sensitivity. 4 After the parameters of the parking lot system operation detection equipment are set, the parking lot system will be operated in a continuous manner. Through the access detection of the whole system, the functions of gate opening, ticket box card out, card swiping and billing, image recording, data query and so on, the parking lot system will be adjusted in time in case of problems during operation, Until the system can stably and efficiently complete the parking access charge management, it can be officially put into use.