Troubleshooting Caused by Loose Screws of Parking Lot Gate_ Taigewang Technology

The parking lot gate is the basic equipment and key equipment of the parking lot system. If the gate does not operate normally, the parking lot is basically paralyzed. The basic principles of the parking lot gate are similar. They are all composed of controller, reducer, motor, transmission mechanism, chassis, brake rod and brake rod support. Other advanced properties such as integrated movement, anti smashing function and temperature rise and fall function are just added on its basis. Today, I'd like to introduce the troubleshooting of common faults of the gate. These faults are mainly caused by loose parts, and the troubleshooting is relatively simple. If the ground induction coil is not buried firmly, coupled with the vibration when the car passes by, it will cause the coil deformation, resulting in the initial inductance of the ground induction. At this time, it is necessary to restart the sensor gate to work normally, which is very troublesome. The solution is very simple. Just pour melted asphalt into the trunking and fix the coil. The movable joint screw is used to connect the upper and lower bearings. If it is loose, it will cause inaccurate connection between them. The solution is to use an 80mm long screw Ф The iron bar of 4 is inserted between the double headed screws and rotated for adjustment to make the brake rod in place up and down. The loosening of the crank arm screw will cause the inaccurate up and down position of the road gate rod, and the rod will shake greatly when stopping. We just need to tighten the screw. It can be solved by tightening the nut. 4. The pull-down hook is used to pull the spring of the balance mechanism and the zero adjustment of the balance function. If the screw on it is loose, it will cause balance imbalance and cause the load of other components such as reducer and motor, which will affect the service life of the gate. The solution is to tighten it. Well, let's introduce the troubleshooting caused by the loosening of the turnstile screw. Thank you for reading.