Specification for Installation of Parking Lot Toll Machines - Tigerwong

As we all know, the toll machine is a basic part of the parking lot system. Whether its installation is standardized affects the stability of operation. How to install the parking lot toll machine? This is what we want to introduce today. In fact, the installation of parking lot toll machine is not complicated. It mainly has two parts: one is the fixation of the chassis, and the other is the wiring. 1 The fixed installation of the toll machine must ensure the stability of the machine. Here, we should place the chassis at the position to be installed according to the specific situation of the site environment, open the door after confirming that it is correct, mark the installation position of screws on the fixing hole with a pencil, and remove the toll machine after marking 14. Fix the fixing screw with the impact drill bit, and then 12. Fix the gate with expansion screws. Here, pay attention to install gaskets and spring pads to fix the toll machine. Finally, clean the toll machine, wipe the equipment with cotton cloth, and the fixed installation of the toll machine is completed. 2 After the wiring box of the toll machine is fixed, the next step is to connect. The wiring shall be carried out according to the wiring diagram. I won't say much here, but only some other details. The internal line identification of the chassis shall be clear. If it is not clear, it needs to be re identified; A margin line of about 1m shall be reserved for the length of the ruler measuring line; First press the wire on the sleeve nose, and then connect it to the terminal of the chassis according to the wiring diagram; Finally, check whether the connection with the chassis port is correct and whether the terminal is tightened; After these two steps, the installation of the toll machine is completed. However, in order to make the machine stable and lightning proof, the following two points need to be paid attention to: 1. In the wiring process, the power line and signal line, such as control line and communication line, must be laid separately and sleeved with on-line pipe. 2. In terms of lightning protection, the ground terminal of the toll collector must be in good contact with the power ground, and so must the shielding layer of the communication line.