Manufacturer - Installation of Parking Lot License Plate Recognition System - Tigerwong

Manufacturer - license plate recognition system shed device. The performance loss rate of vehicles temporarily parked in the open air is twice that of vehicles parked in the shed. The canopy with membrane structure can really take care of your car. Slow down the aging of your car. From an economic point of view, the investment is not much, but it greatly prolongs the life of your horse.

Light transmittance: good light transmittance (20% light transmittance). Exposure to sunlight will not produce yellowing, atomization and poor light transmittance. Weather resistance: there is an anti ultraviolet coextrusion layer on the surface, which can prevent resin fatigue yellowing caused by solar ultraviolet rays. The external coextrusion layer can chemically absorb ultraviolet rays and convert them into visible light. It has a good stabilizing effect on plant photosynthesis (it is very suitable for maintaining all kinds of cars, valuable works of art and exhibits from ultraviolet damage) the membrane structure shed is composed of a variety of high-strength membrane materials and reinforcing components (steel frame, steel column or steel cable) In a certain way, a certain pretension stress is generated inside it to form a certain spatial shape. As a covering structure, it can bear a certain external load.

The planning and construction of parking lot has become an important part of modern rural planning. It has become more and more important. The lightweight and novel shape of membrane structure plays an important role in the construction of parking lot and waiting hall In addition to meeting the basic functions of wind and rain protection and sun protection, the license plate recognition system has a better identification effect. It shows people's personalization. The inner membrane of the membrane structure is usually welded by the galvanized circular pipe to the frame of the tent, so it is necessary to put the prefabricated parts into the shed, then the charging pile shed manufacturer - the membrane structure parking garage device. Use screws to carry out the two.

Secondary reinforcement to enhance the wind strength and improve the overall firmness. The data to be recorded include the working temperature of the heat sealing equipment. During the heat sealing process of PTEE diaphragm. The pressure and heating time shall be determined by the seal strip tensile test according to different data combination and cooling time parameters, and the relevant data shall be recorded. During the heat sealing process, the heat shall be determined according to the two parameters The crease caused by the tensile force of the two diaphragms is not a plane diaphragm, which can effectively control the thermal shrinkage rate and ensure that the sealing area is clean and free of dust, and there are no sundries that can be adsorbed by static electricity.

The two sealing materials of the membrane structure parking shed of the license plate recognition system must also be hot-melt welded, and no weld is allowed to exist, so as to ensure sufficient strength and good water sealing performance The membrane and waste membrane shall not be folded directly when they are treated. At this time, some curled or folded soft materials shall be used for padding, and attention shall be paid not to decolorization when selecting packaging materials. The shape of membrane surface shall be maintained by relying on the air pressure difference inside and outside the surface, and the inflatable membrane structure is to fix the membrane material around the roof structure After the air supply system makes the indoor air pressure rise to a certain pressure, there will be a pressure difference inside and outside the roof to resist external forces. Because it is supported by air pressure, the inflatable membrane structure is the indoor air composed of membrane structure. It is insisted that the indoor air pressure is always greater than the outdoor air pressure, so that the membrane data is in a tension state to resist the structural form of load and external forces, and the steel cable is used as Auxiliary materials, without any beam and column support, can get more space.

The air film structure is divided into single-layer structure and double-layer structure. The single-layer structure is like soap bubbles, and the internal pressure of the single-layer film is greater than the external pressure.