How to Reasonably Layout and Debug the Integrated License Plate Recognition Machine During Installat

With the progress of modern management means and the increasing development of science and technology, community users have a higher demand for vehicle management. The past management mode of manual card swiping can no longer meet the needs of modern development. In view of the current fast-paced and high-speed work mode, it is required that the management methods and systems should be fundamentally improved. This improvement should not only meet the needs of community management, but also meet the needs of society, people's senses and habitual operation. The license plate recognition management system is very suitable for the needs of the society. Of course, it's not just about installing a system. Some details are the most important, such as the installation and debugging of license plate recognition camera. Tigerwong automatic license plate recognition system adopts high-definition integrated network camera. The camera has its own recognition algorithm and built-in multi-core CPU chip. It has high recognition rate, fast recognition speed and stable performance. Strong light suppression and brightness compensation can ensure that the equipment can better adapt to different places in different regions. The use of split high brightness controllable led fill light can greatly improve the license plate recognition rate. The system can be compatible with two working modes: sensing trigger and video stream trigger. It has a wide range of applications. It can automatically recognize the license plate of temporary vehicles, charge according to the entry and exit time, and there is no need to pick up the card. Vehicles can enter and leave the parking lot without obstacles, providing users with a new service mode. What should be paid attention to in the debugging of license plate recognition camera? 1. Selection of installation position of tigerwong camera: if the straight road distance is more than 8m and there is no truck on the site, if the lane width is not more than 4.5m, the camera can be installed on either side of the road. The straight road distance is relatively short or the curve installation equipment is very important for the selection of position, so it must be installed on the outside of the curve and not on the inside of the curve, Otherwise, the recognition rate will be greatly reduced. 2. Adjustment of camera height: the best distance of camera center point is 4-4.5m. 3. How to determine whether the camera is horizontal: from the camera picture, it is the best level when the vehicle body does not tilt left and right. 4. Determination of left and right angles: it is best for the license plate to pass through the center point. 5. Camera parameter settings for special scenes: forward and backward light: in the environment of forward and backward light, it is necessary to turn on the fill light, and appropriately lower the shutter and gain. 6. Bridge and tunnel mode and basement entrance: turn on the fill light, and turn on the wide dynamic. At present, no high-tech product can completely replace human manual operation, human thinking, and human way of thinking. Therefore, when designing the automatic management system, we should emphasize the automatic means as much as possible, but we can not ignore the factors of manual intervention. The ingenious combination of the two can achieve twice the result with half the effort. Tiger Wong parking management system has a professional technical team! If you have any questions about parking lot system, etc., welcome to consult and exchange.