What Should We Pay Attention to When Cutting the Ground Induction Coil in the Intelligent Parking Lo

As an important equipment used to manage vehicles in the parking lot, intelligent car parking system operates 24 hours a day. The stability of its equipment will directly affect the operation of the parking lot. Therefore, in the process of installing and using the parking lot system, it must be in strict accordance with the requirements of the equipment, As a part of the parking lot system used to sense the entry and exit of vehicles, what should be paid attention to when cutting? Before cutting the earth induction coil, we must first ensure that there is no small amount of metal within about 50 cm around, such as well cover, rainwater ditch cover, etc; Secondly, do a good job within 1m of the cutting line, and do not have high-voltage lines; Moreover, if multiple ground induction coils are cut, the interval between coils shall be greater than 2m, otherwise they will interfere with each other. During our construction, we should ensure that the depth and width of the coil slot should be uniform, and try to avoid sudden depth, shallow width and narrow. After cutting, we should ensure that there are no sundries, especially hard objects, in the coil slot. When approaching the safety island, we should avoid the lead exposed on the road. When installing the ground induction coil, in order to prevent the wires in the slot from being cut by hard edges and corners for a long time, we'd better lay some fine sand in the slot; The wires in the trough shall be pressed tightly to the bottom of the trough as far as possible without stress; After laying the wires in the trunking, in order to prevent the coil skin from melting at high temperature, we try to cover the paved coil with a layer of fine sand. Finally, we pour it repeatedly with melted asphalt until it is flush with the road surface, so that we can complete the cutting of the ground induction coil. Although the ground induction coil is a small part of the parking lot, it must find a regular parking lot system manufacturer for guidance when cutting. It is not only related to the normal operation of the parking lot, but also affects the service life of the parking lot system.