What Are the Precautions for the Installation of Expressway Gate- Parking Lot Management System

In order to solve this problem, the high-speed vehicle management system introduces reliable high-speed road gate equipment. Highway gate system has been widely used in highway toll stations to optimize and limit the driving management of motor vehicles. Because the installation of high-speed gate directly affects its normal service efficiency and service life, the following small series introduces three installation matters of high-speed gate. 1. Pay attention to the installation of line embedded highway gate. First, pay attention to the line embedded work. Firstly, the line shall be embedded on the horizontal road, and then the appropriate box position shall be selected and determined. The base of the expressway gate shall be completed by pouring concrete. The fixed position of the chassis shall be between the control room and the sentry box. The cable trench shall be embedded and excavated in this section. The power line and control line shall be accurately backfilled with concrete. 2. Pay attention to the installation of the ground induction coil high-speed gate, pay attention to the coordination with the ground induction coil, and ensure that the output section of the ground induction coil can be twisted to the gate, and the shorter the distance, the better. After the ground induction coil is connected, the nest must be sealed. At the same time, it shall be noted that the sensing coil shall not be damaged during the laying process, so as to avoid the problem that the expressway gate cannot open and fall normally, so as to hinder the normal operation of motor vehicles. 3. Note that the gate rod of the high-speed gate has adjusted the spring to the torque balance position before leaving the factory. If it is necessary to adjust the length of the expressway gate rod according to the site conditions, first adjust the spring force to balance, and then lengthen and cut it appropriately. The installation of the high-speed road gate rod shall be equipped with screws to prevent the road gate rod from falling off. It can be seen from the above that attention must be paid to line embedding, ground induction coil matching and gate rod installation in the installation of Expressway gate. At the same time, after the installation of the high-speed gate, the installation and commissioning shall be carried out to meet the needs of customers. At present, there are many affordable high-speed gate products available for sale, and people can easily enjoy the convenience of high-speed gate.