Precautions for Installation of Parking Equipment, Safety Island and Sentry Box in Intelligent Parki

Now many parking lots need to transform the parking lot into an intelligent one. Let's briefly talk about the installation and precautions of parking lot equipment, safety island and sentry box in the intelligent parking lot. First, safety island and safety island are mainly used to place parking lot equipment and prevent vehicle collision. Some parking lots need to be installed, while others do not need to be installed. The installation of safety island has the following requirements: 1. Size of safety island. The height of the safety island is generally 10 to 15 cm higher than the ground, and the equipment installation area is more than 10 cm larger than the equipment size, which is considered to prevent the expansion of the fixing screw from damaging the platform. 2. If a safety island is built on the earth ground, it is required to dig a pit, and the safety island shall be more than 30cm deep into the ground. 3. If it is on the cement pavement or asphalt pavement, a safety island can be built directly on the ground, but it needs to be reinforced. The method is to make a steel bar (& phi; more than 20) every 25 cm with star makeup. The steel bar should be more than 5 cm deep into the ground and more than 5 cm exposed. 4. Material requirements for the safety island: the ratio of cement to sand is 1:2. The national standard 425# Portland cement and medium sand shall be used, and soil, brick and other materials shall not be used. 2、 Sentry box sentry box is mainly used to manage temporary vehicles and charges. For some parking lots without temporary vehicles, you can also not set up sentry box. It depends on the demand. The position of the sentry box is generally set up at the entrance and exit to facilitate the management of fees. The sentry box will generally place parking lot management computers and other equipment, and there will be staff working in it, with an area of more than 4 square meters. 3、 Installation parameters of other parking lot equipment. Now let's summarize the installation parameters of parking lot equipment. 1. The distance between the parking lot management computer and the card reader should be less than 100m, which is generally placed in the sentry box; 2. The center distance between the card reader and the gate is generally more than 2m, preferably about 2.5m; 3. The installation height of license plate recognition camera is between 2M and 2.5m; 4. The size of ground induction coil is 2m * 0.8m; 5. The minimum area of the sentry box is 2. * 2m, that is, 4m2; 6. The lane width of the parking lot shall be greater than 3m;