One in One Out Parking Lot Card Reader and Gate Installation Location - Tigerwong

How to determine the installation location of the equipment in the intelligent parking lot? In addition to the on-site environmental factors, the installation position of the equipment should also pay attention to the following points, which we will explain. 1. Installation position of gate and card reading equipment. For ground parking lots, their placement shall ensure smooth access of vehicles and sufficient width of lanes. Generally, the lane of parking lot shall not be less than 2.5m, and the best distance is 3.5m. The distance between the gate and the card reading equipment shall not be less than 2m, preferably 2.5m, in order to prevent the vehicle from hitting the gate rod during card reading. In the underground parking lot, due to the slope, the card reading equipment should be installed on a relatively high level ground, so that the driver can read the card more conveniently. For the installation of the gate, attention should be paid to whether there is a barrier above the gate. If there is a barrier, the straight rod cannot be selected, and the folding gate should be selected. The position of the folding rod point should be about 1.2m below the barrier. Generally speaking, it is necessary to determine the installation position of the card reading equipment and the gate, and then lay the pipeline, so as to avoid the problem of rewiring due to changing the installation position. In actual operation, the card reading equipment and the gate shall be installed first, and then Party A's personnel shall be invited to simulate the use together. After both parties are satisfied, the pipeline shall be laid. 2. Installation position of automatic card reader and camera if the automatic card reader is an independent device, such as Bluetooth card reader, its installation position should be in the front, about 0.3m away from the card reader. The installation height of the camera is between 2 and 2.5m, equipped with automatic aperture lens, and the viewing angle range is set at the position of the license plate when the vehicle reads the card.