How to Install the Parking Lot System Gate and What Should Be Paid Attention to- TigerWong Technolog

As an important part of the parking lot, if the parking lot gate system is improperly installed in the process of use, there will often be failures such as failure to open and drop the gate normally, failure to automatically drop the gate after passing, overheating of the gate motor and excessive wear of the gate reducer. How to ensure the correct installation of the gate, the gate manufacturer Installation requirements for parking lot system of cloud parking Shenzhen tigerwong Technology Co., Ltd. how to install the gate? 1. In order to avoid rain erosion, and equipment are generally installed on the safety island. If there is no safety island, it is recommended to build a equipment installation foundation with a height of 15cm. Length and width: ensure that the box and the edge of the foundation are about 10cm [generally 150mmx500mmx500mm]. Bottom & phi; 12mmx100mm expansion screw is locked and fixed. 2. Embedding and positioning of ground induction coil: generally, the coil is 2m x 1m, and the coil position is determined by the installation position of the on-site gate. Taking the vertical lower end of the gate rod as the starting point, the coil in the outlet direction accounts for 2 / 3 and the coil in the inlet direction accounts for 1 / 3; For example, for a 1m wide coil, take the road gate rod as the center: 66.6cm to the side of the outlet coil; 33.3 cm to the side of the inlet coil. 3. Cutting of cement floor: the depth shall be about 3cm, the four corners shall be cut into oblique angles, and the national standard 0.75mm Teflon wire shall be used for embedding. After the last round of winding, it is recommended to press the waste wire skin point by point to ensure that the wire is not exposed to the ground. Winding 5-6 turns to ensure that the total length of the coil is not less than 30m, generally 30-50m. The winding shall be tightened in the slot, and the outgoing line shall be twisted in pairs at least 30 times per meter. 4. Vehicle detector: under normal conditions: 1 and 2 are connected to 220V power supply, 7 and 8 are connected to coil, and 3 and 4 are connected to ground induction input of main board of barrier gate. Broadcast code sensitivity: l (low) m (medium) H (high), generally L (low) or m (medium). 5. After the system is connected, power on test - iron plate overvoltage coil can be used. When the signal is detected, the indicator light turns green. After the iron plate leaves the coil, the gate will close automatically. Tiger Wong parking management system has a professional technical team! If you have any questions about parking lot system, etc., welcome to consult and exchange.