How to Install the Gate of Intelligent Parking Lot to Meet the Specification_ Taigewang Technology

The parking lot gate looks simple, but some details need to be paid attention to in installation. These details can make the service life of the gate longer and the operation of staff more convenient. Here are some points to note. For the installation of control machine and gate, it should be noted that the equipment must be installed firmly without shaking. When it can bear 100kg / s impulse, the equipment will not shift or loosen. The connection between the bottom of the control machine and the gate box and the ground shall be tight, and there shall be no gap. If there is a gap, it shall be leveled and sealed with cement. The position of the box shall not exceed the lane line and shall be at least 5cm away from the edge of the lane. The inlet control machine shall be installed on the left side of the vehicle entry deviation to facilitate the driver's card swiping. The gate display screen shall be installed perpendicular to the ground, and the inclination angle shall be controlled at 1 & deg;, It is installed where drivers can easily see it, so that they can reverse. The installation principle of the gate control button is to facilitate the operation of the staff, which is generally installed locally. The installation of surveillance camera mainly focuses on the installation of camera bracket, which should be perpendicular to the ground and the inclination should not be greater than 1 & deg;, The base shall be in close and stable contact with the ground, shall not exceed the lane line, and shall not shake, so as to ensure the stable shooting and capture of the surveillance camera. Well, the above is the technical requirements for the installation of the gate of the intelligent parking lot system. Thank you for reading.