How to Deal with the Common Faults of the Gate in the Parking Lot System- TigerWong

The parking lot system is now a highly intelligent product. The road gate is the electromechanical integration equipment at the core of the parking lot system. The operator controls the action of the lifting gate for vehicles in and out of the parking lot to ensure the normal operation of the parking lot. Since it is an electromechanical equipment, it will always encounter some faults. Tigerwong technology summarizes the common faults and solutions in the use of the gate. In the normal state of the first gate, the falling rod is higher or lower than the horizontal position. If the falling rod of the first gate is higher than the horizontal position, first check whether the lower limit switch controlled by the first falling rod is loose, and then tighten the lower limit screw; Whether the barrier of the gate is shortened or folded, and the length of the tension spring can be adjusted through fine adjustment of the screw sleeve; Readjust the gate machine to the horizontal position and tighten the screws. When it is lower than the horizontal position, check whether the screws of the limit switch are loose, whether the railing has heavy garbage load, the wear of the worm wheel of the gate motor, the poor self-locking performance, and the failure of the limit function. Clean the railing, adjust the screw sleeve, replace the worm, re debug the correct position and tighten the screws. The second gate receives the signal and cannot complete the action normally. This situation is often encountered. After receiving the signal, the gate either does not act or cannot be reset after the action. There are also abnormal gate lifting actions such as giving a signal. Make more back and forth rod dropping and rod raising signals for the gate to reset the gate, check the dial switch behind the gate, reset the dial switch and adjust it to normal use; Check whether the motor is stuck or damaged, and maintain or replace the motor; Check the electrical and electronic devices according to the electrical drawings of the gate, and replace and deal with the electrically damaged circuit boards, capacitors and wires. The above are the common problems of the gate. If a friend has problems that are difficult to solve in the gate system of the parking lot, you can consult the after-sales service department of Shenzhen tigerwong, and there will be staff with rich technical experience to answer them for you.