Gate Manufacturer Card Reader and Gate Installation Location - Tigerwong

The card reader of the gate manufacturer and the installation position of the gate can read the card without stopping, so as to improve the traffic speed of vehicles. 3. There is no need to open the window to read the card. Even if the vehicle is pasted with explosion-proof film, it will not be affected. It is more convenient to swipe the card in windy, rainy and snowy weather. 4. There is no need to worry about mutual interference between card readers. Bluetooth communication technology and code division multiple access are adopted to effectively solve the problem of mutual interference between front, rear, left and right lanes. Generally, the gate rod of the road gate shall not exceed 5.5m, and the conventional straight rod shall be 6m, the curved rod shall be 5m, the second fence shall be 4.5m and the third fence shall be 4m. If the length of the gate rod is more than 5m, a support shall be installed at the other end. The road gate is generally installed on the left side of the entrance and exit. The installation ground is horizontal and firm, and strive to be stable. There shall be no shaking when there are vehicles passing by. If it is an underground parking lot, pay attention to whether the straight rod can be used for the height above the gate. Generally speaking, the curved rod is used, and the folding point is generally about 1.2m below the barrier. The ground induction coil shall be installed directly below the gate rod of the road gate. The wiring of the ground induction coil is to cut the ground into a square nest with a depth of 10cm and 2x0.8m, and the four corners are cut into an oblique angle of 45 . It is recommended to put the ground induction coil in circles, generally 5 6 layers. Each layer of the coil * is compressed. There shall be no connector inside the coil. The output end of the ground induction coil is twisted to the gate. And the shorter the distance, the better. After connecting, seal the nest with dry cement; How to determine the installation location of the equipment in the intelligent parking lot? In addition to the on-site environmental factors, the installation position of the equipment should also pay attention to the following points, which we will explain. The installation position of road gates and card reading equipment for the ground parking lot shall ensure the smooth access of vehicles and give sufficient width to the lane. Generally, the lane of the parking lot of the gate manufacturer shall not be less than 2.5m, * the distance is 3.5m. The distance between the gate and the card reading equipment shall not be less than 2 meters, * at 2.5 meters, which is to prevent the vehicle from hitting the gate rod during card reading.