Brand of Parking Lot Management System -- Tigerwong - Tigerwong

The parking lot management system has fault self-test function (it can automatically detect whether the gate, ground sensor, card dispenser, display screen and main board work normally). The management personnel can query the current parking situation in the parking lot at any time in the Beijing parking lot system management center; Entry and exit records at any time and relevant images can be viewed; You can query by user-defined query scheme (universal query). User-defined query scheme can be saved and edited; When the system is full, it can send the command not to read the card to the main control board. However, the card can still be issued by issuing the card command through the computer. The parking lot management system software can control the opening, closing and stopping of the gate, and can detect the opening, closing and stopping status of the gate in real time. And the status of full card, no card, less card, card machine error, etc. Whether all types of cards in the parking lot system are allowed to continue to read after they are full, whether there is ground sensing, card reading when the gate is closed in place, the delay time of card reading opening is adjustable, the overtime exit time after fixed-point charging is adjustable, the automatic card swallowing time when the card dispenser times out without taking the card is adjustable, and the amount of cards received by the card dispenser exceeds the card receiving amount is adjustable through computer settings. The parking lot system has the functions of full space prompt and no card reading.

If the parking space in the parking lot is full, the parking lot system displays that the parking lot is full. At the same time, the key of the card exit machine of the parking lot system is prohibited, but the computer card is valid. The monthly card user can realize the remote extension mode, and the mainboard jumper can select the monthly card use mode: 1 convention mode. 2 remote mode. 3. The entrance and exit shall be postponed. Jumper can be used to select whether it is closed in place to pick up and read cards. This method can be used by the parking lot system to realize one card per vehicle to prevent card loss.

Add the recording function of illegal card and illegal opening of gate. With image comparison function. It has networking function. Rare faults of parking lot management system and troubleshooting methods 1. All communication of card readers are blocked. 1. Check whether each card reader is normally powered on. 2. Check whether the serial port is set incorrectly. Determine the serial port used. 3. Check whether there is a short circuit or open circuit in the communication bus. Eliminate the short circuit and open circuit of the communication line. 4) the communication chip 75184 of RS485 communication card is damaged. Replace the communication chip 751845rs485 If the communication card is damaged, replace the RS485 communication card) 2. The local communication of the card reader is blocked. 1. Check whether the card reader is normally powered on. 2. Check whether the machine number setting of the card reader is correct.

Determine whether the machine number is reset). 3. Check whether the communication chip of the card reader board is damaged. Replace the communication chip). 4. Check whether the read-write chip of the card reader board is damaged. Replace the read-write chip). 5. Check whether the read-write module of the card reader board is damaged Bad replace the read-write module) 6. Replace the card reader board in case of failure) 3. All cards cannot be read after the card reader is turned on normally. 1. Determine whether the equipment has a car to read the card and provide the card reading after the simulated vehicle is pressed on the ground) 2. Check whether the time of the card reader is correct and give the correct time to reload) 4. Some cards cannot be read after the card reader is turned on normally. 1. Check whether the IC card is reported lost and clear the card reader Loss report record) 2 check whether the IC card has expired and give the IC card an extension) if there is an opening signal output, 1 check whether the card reading board outputs an opening signal after card reading. Explain that the fault lies in the gate; 2. Check whether the opening signal line between the card reading board and the gate is open (eliminate the open circuit). 3. The card reading board opening output circuit optocoupler or triode (9013 is damaged, replace the optocoupler or triode) 4. The card reading board is faulty (replace the card reading board) 6. There is no import and export image after entering the access management. 1. Check whether the video cable is plugged in properly (plug in the video plug). 2. Check whether the video cable connector is aging and desoldered. Remake the video connector). 3. Check whether the camera transformer is damaged (replace the transformer).