Automatic License Plate Recognition System Customized - Tigerwong

Easy to use, the license plate recognition system is customized for remote garage door 1 microcomputer sequence control. Press the remote control handle, and the motor is equipped with automatic delay lamp. Garage door tjhm rare faults and maintenance methods 1. The driving device cannot be started with manual switch or remote control: possible causes: 1. The driving device is not powered on. 2. Open circuit of manual switch or remote control receiving board. 3. Maintenance method of motor thermal protection caused by excessive operation times: 1. Check socket, plug, manual switch and safety tube fuse. 2 check the wiring of manual switch and remote control receiving board. 3 reposition the travel switch to increase travel. 2 Automatic reverse operation without closing the door tightly or stop operation without touching the travel switch when opening the door: possible causes: 1. The opening and closing resistance is greater than the set opening and closing load force, which activates the obstacle sensing system. 2. Improper adjustment of connecting rod length. Maintenance method: check whether the door body and torsion spring are balanced and whether the opening and closing are flexible. 1 open the clutch device. 2 increase the opening and closing load force. 3 adjust the length of the connecting rod when the door is closed. Reel, locking flange. The bearing support shall be sleeved on the galvanized steel pipe in sequence (distinguish the left and right sides), and pay attention to whether all parts are installed correctly.

Use M8 * 41mm square head screw to fix the torsion spring center support to the short wooden board in the middle of the upper part of the hole, and pay attention to avoid the device position of the chain box. Connect the torsion spring center support, nylon rubber ring, fixed flange and torsion spring with M8 * 40MM bolts, and then connect the torsion spring and locking flange. Fix the flange nylon rubber ring to fix the torsion spring center support, and then connect and fix the lower end of the bearing support with the horizontal rail connector with m9.5 * 19mm large cap screws and nuts. The upper end of the torsion spring bearing bracket matching the weight of the door body is fixed to the side wooden frame with M8 * 41mm square head screws. No person or object is allowed to pass under the door.

The license plate recognition system is customized when the door is running. Or stay under the door body. 3. It is forbidden to operate the remote controller where the operation of the door body cannot be seen, so as to avoid safety accidents or wrong opening of the garage door. 4. The horizontal guide on both sides of the door body meets the requirements, quality specifications and safety standards. It is a good choice for customers to buy automatic doors. The design of villa parking lot can realize multi-functional opening and closing modes such as manual, electric and remote control. The door body is rigid and integral. It has high strength, good rigidity and strong protective performance.

The door has the characteristics of unique shape, elegant quality, smooth opening and closing, safe and fast. It is suitable for small and medium-sized garage doors with a height of no less than 3m or full-automatic garage doors in special places. Manual can be used in case of power failure. Features: 1. Remote control or electric control can be used when there is power. Rise to the open position. 2. When the garage door descends, it can automatically reverse in case of obstacles.When the moving object falls through the door, the door can automatically stop falling. 3. The far-infrared switching device can be selected. The license plate recognition system reverses and rises to the door opening position. Equipped with power failure emergency door lock. No noise is received in the door, and the 4 door body is turned up and opened vertically. It does not occupy the ground, which is conducive to layout and save space.