Analysis on Anti Smashing Technology of Road Gate in Intelligent Parking Lot_ Taigewang Technology

As a modern management equipment in parking lot, intelligent parking lot management system has been applied in major parking places. As an intelligent management equipment in the parking lot, the car smashing phenomenon of the gate still occurs from time to time. How to avoid the car smashing phenomenon of the gate, and what are the corresponding anti smashing technologies in the parking lot system? The barrier is an important part of the parking lot system. It plays the role of one car and one gear in the parking lot. However, due to its improper use or some of its own factors, it is common to see vehicles smashed or pedestrians smashed. So how to prevent and avoid such incidents? As the second enterprise landing in the capital market in the import and export field, taigewang technology briefly introduces several anti smashing technologies of the road gate in the intelligent parking lot. With the continuous development of technology, there are several anti smashing technologies for the parking lot gate at present: 1. Ground sense anti smashing technology. When the parking lot system is installed in the general parking lot, the front and rear ground senses will be installed at the entrance and exit of the parking lot. When the vehicle enters the parking lot, the first ground sense trigger signal will be detected, and the gate will lift the rod, When the vehicle passes through the second ground sense at the entrance, the ground sense signal disappears and the gate will fall off. However, after the ground sense anti smashing is disturbed by the outside world, it may fail and does not have the function of anti smashing people. 2. Infrared anti smashing technology. This anti smashing technology is to install infrared radiation devices on both sides of the gate in the parking lot charging system. When the vehicle drives to the entrance and exit, the infrared is blocked, and the gate will rise automatically and respond quickly. 3. Pressure wave anti smashing technology. This anti smashing technology is mainly in the process of falling of the gate. If vehicles or pedestrians are encountered, the rubber strip installed at the bottom of the gate rod will be resisted, and the gate will convert the falling gate rod into a rising state. This anti smashing technology is not only anti smashing of vehicles and people, but also an anti smashing technology widely used at present. With these anti smashing technologies, the gate in the parking lot system can avoid the occurrence of car smashing accidents, avoid some unnecessary disputes, and increase the income for the parking lot.