You can control both energy and video cabling on your security cameras or DVR if you use a wired surveillance system. The risk of a failure or accident that can be fixed exists throughout these cables. We can send you some ideas that can help in your network cable preplanning and troubleshooting.
Power & Distance:The longer you have the wire, the more susceptible you are to voltage falls and a signal loss. You may note that your device is completely inefficient or a low or spotty signal or sporadic usability. You can get a couple of hundred feet without too much trouble by using a 12V safety camera and electricity; but if you go beyond that distance, you cannot keep a signal.
The 24V power supply with a 12V transformer by the lens is one way to compensate it. That gives your signal the additional power it needs to keep your connection strong and stable. For a fact, you will want to switch to 24 V power supplies with lower volt-amp levels as the ranges rise more.
A high VA rating gives it's signal more power and strength.Fuzzy/Distorted Picture:You can end up with a liquid or blurred image after everything has been fully together, depending on your surveillance system specification. This can be due to a number of things; including coiled wiring that causes the effect of the ground loop.
The important thing to note is that it is very difficult to predict and that it cannot take into account all possibilities. Nevertheless, the good news is that by using a solar loop isolator, such as the COP-USA 15-GL01, or adding the separated signal between your lens and your DVR, the question can typically be avoided.Aluminum Wire:In many houses, the use of aluminum braid coax cables for high-end TV systems and entertainment services is strongly preferred.
This can cause all kinds of headaches for CCTV equipment while this is an excellent thing for these applications.Basically, the thing you should note is that you might end up with a fluffy picture or loss of signal when you plan to use existing cabling on your home for your monitoring system instead of new wire runs. This is because aluminum cabling cannot accommodate the CCTV constant video signal that can be provided by copper wire as effectively.
However, the way to address this problem is through the use of a video distribution device to adjust the luminance, gain and another video level of your video signals. If you do, you can adjust the cable video rates to perfect conditions where the transmission can be managed periodically. The only thing is, you will either have to practice with them for hours in order to learn what your video signal check the meter is or you will have to find someone who is able to monitor the performance.
Australian security wholesale has worked in the surveillance industry for over 18 years. learn more about surveillance, and find great products at
Shenzhen TigerWong Technology Co.,Ltd
Tel: +86 0755-23773884
Add: Room 601-605, Building 6, 1980 Science and Technology Industrial Park, Longhua Street, Longhua District, Shenzhen